Start > Start
1
2
COMMAND CENTER
• Access linked home pages
All users will have access to the Start page.
This page allows you to verify the machine's operating status. This will be the
first screen that appears after COMMAND CENTER has been started up.
Select Language
Appears if COMMAND CENTER pages support multiple languages. To
change COMMAND CENTER language:
Open the Select Language drop down list by clicking it.
Select the appropriate language.
If you attempt to view COMMAND CENTER with a character set other than
the language that is used on the operation panel's display, some characters
may be illegible.
Operation Panel
This indicates the machine's operating status as displayed on the operation
panel. To update the display to the most recent status, click the Refresh
button.
Toner Level
This shows the approximate level of remaining toner. The closer the value to
0%, the smaller the amount of remaining toner. If you use non-original toner
kit, the toner gauge measurement will not be indicated correctly.
Network IP Information
Network IP information on the printing system is displayed. This allows you
to verify the following information:
• IP Address
• IPv6 Address (Manual)
• IPv6 Address (LinkLocal)
• IPv6 Addresses 1 to 5 (Stateless)
• IPv6 Address (Stateful)
• Host Name
System Identification
System information on the printing system is displayed. This allows you to
verify the following information:
• MAC Address
• System Firmware
• Engine Firmware
• Panel Firmware
• FAX Firmware
• Serial Number
• Asset Number
Media Input
COMMAND CENTER Pages
3-2