Advanced > Protocols > Tcp/Ip > Logical Printers - Kyocera FS C5015N - Color LED Printer Operation Manual

Advanced > Protocols > TCP/IP > Logical Printers
COMMAND CENTER
• LPD
• FTP
• IPP
• ThinPrint
• HTTP
• Raw
• SNMP
• IPP over SSL
• HTTPS
IP Filters (IPv6)
• IP Address (IPv6)
Specifies the IP addresses to which access is granted. The number of
addresses that can be specified varies depending on the model used.
• Prefix Length
Specifies the IPv6 prefix length. It can be a decimal value between 0 and 128.
• Protocols
Specifies the protocols through which access is granted. The following
protocols can be selected.
• LPD
• FTP
• IPP
• ThinPrint
• HTTP
• Raw
• SNMP
• IPP over SSL
• HTTPS
This page allows you to configure the Logical Printers. This machine can be
used as a virtual printer for converting ASCII print data to PostScript data or for
adding and/or replacing a character strings (commands) at the beginning or end
of job data. Up to four logical printers can be set.
Each logical printer can be used with either the FTP, LPR, IPP, NetBEUI, or
Raw Port protocol. All printout to a non-existent port will be accomplished to
Logical Printer1.
TCP/IP Port Number
Specifies the port number for the logical printer as well as the TCP raw port
number (9100, etc.). Conversion is applied to data that is input to the
specified raw port in accordance with the selected logical printer. This port is
invalid if it is given a port number that is the same as that of an already
specified port (For example, FTP or LPD).
Bi-directional Printing
On or Off Bi-directional Printing using the TCP/IP raw port. With this setting
Off, all send data are discarded. In order to have the data that is received
COMMAND CENTER Pages
3-38