Kyocera FS C5015N - Color LED Printer Operation Manual page 29

3
COMMAND CENTER
Give the condition set here an easily recognizable name.
Status
Specify whether to enable or disable the condition. This item is set to Off for
the condition that has just been added. To set this item to On, set the
conditions and then click to select the desired condition on the Requirement
List and change the setting. If the requirement sets include the same
Activating Time Setting, Activating Time and Sub Address settings,
these requirement sets will not be enabled at the same time.
Activating Time
Specify a period of hours during which the forwarding process is executed.
Select Time Specification to forward only faxes received during a particular
period of hours or All Day not to specify the hours.
Enable Time
When Time Specification is selected in the previous item, specify the start
time and end time.
File Name
Specify the file name to be used for the forwarded file.
Additional Information
Specify the information to be added to the file name specified in the previous
item.
Add Sender Information
Determine whether the sender information are added to the file name or not.
Priority
Prioritize the search keys when conducting searching over the sending
criterions.
Requirement Type
Select the condition type from the following items.
- FAX Sub Address
- FAX Number
- FAX Dial-in Number
- FAX Reception Port
- i-FAX Address
When an item is selected, the text box below it accepts entry of the
necessary information on the selected item. Enter the condition necessary
for each item. Asterisks (*) can be used as wildcards. For example, to
specify all faxes that came from Tokyo, select FAX Number and enter '03*'
in the FAX number text box. For some models which shows Search by when
FAX Number or i-FAX Address is selected, you can use a search criteria
such as Same as or Start with, etc. Wildcards cannot be used for these
models.
When the search criteria is Same as, up to 9 are forwarded to the FAX Box.
FAX Reception Port shows the list in which you can select Port 1 or Port 2.
If you selected FAX Sub Address for Requirement Type, enter a
subaddress subsequently.
After you have finished setting all items, click Submit.
COMMAND CENTER Pages
3-22