Advanced > Protocols > Tcp/Ip > Logical Printers - Kyocera TASKalfa 8000i User Manual

Settings Pages
Advanced > Protocols > TCP/IP > Logical Printers
6-32
• HTTP
• Raw
• SNMP
• IPP over SSL
• HTTPS
IP Filters (IPv6)
• IP Address (IPv6)
Specifies the IP addresses to which access is granted. When there are no
entries, access is allowed to all. The number of addresses that can be
specified depends on the IPv6 network address along with the prefix length
setting. To filter a single IPv6 address: Enter the desired IPv6 address, along
with a prefix length of 128.
• Prefix Length
Specifies the IPv6 prefix length. It can be a decimal value between 0 and 128.
• Protocols
Specifies the protocols through which access is granted. The following
protocols can be selected.
• LPD
• FTP
• IPP
• ThinPrint
• HTTP
• Raw
• SNMP
• IPP over SSL
• HTTPS
This page allows you to configure the Logical Printers. This machine can be
used as a virtual printer for converting ASCII print data to PostScript data or for
adding and/or replacing a character strings (commands) at the beginning or end
of job data. Up to four logical printers can be set.
Each logical printer can be used with either following print protocols: FTP, LPR,
IPP, IPPS, SMB (NetBEUI), or RAW. If no port is specified during print, the
default port used will be Logical Printer 1 (LP1), port 9100.
TCP/IP Port Number
Specifies the port number for the logical printer as well as the TCP raw port
number (9100, etc.). Conversion is applied to data that is input to the
specified raw port in accordance with the selected logical printer. This port is
invalid if it is given a port number that is the same as that of an already
specified port (For example, FTP or LPD).
Bi-directional Printing
Bi-directional Printing can be set to On or Off when printing to the the
TCP/IP RAW port. When Bi-directional Printing = Off, all send data is
discarded. In order to have the data that is received from the printer returned
to the client when printing with PostScript, PJL and other such commands, it
is necessary to set Bi-directional Printing = On.
User Guide