Wireless Interface - D-Link DCS-1000W Manual

The default settings are as follows:
§
Default IP – 192.168.0.20
§
Subnet Mask – 255.255.255.0
§
Default Gateway – 0.0.0.0
Assign Automatically Using
It is recommended that you do not use an Automatically Assigned IP address as
it may be difficult to determine the IP address of the unit after the IP address has
been assigned. It is recommended that an IP address be assigned manually.
If your network is using RARP, BOOTP or DHCP server you can click
"Assign Automatically Using" and click on "RARP", "BOOTP" or
"DHCP" . Under this setting DCS-1000W will automatically assign an IP
address from RARP, BOOTP or DHCP server. Each time the DCS-1000W
starts up be sure the RARP, BOOTP or DHCP server is setup as assign a static
IP to your DCS-1000W.
If your application requires a direct connection from an ADSL modem
through the DCS-1000W's RJ-45 LAN port and you also have an ISP PPPoE
account, click on the "PPPoE" option and enter the Service Name, User ID
and Password into the respective fields.
The DCS-1000W will get an IP address from the ISP each time DCS-1000W
starts up when Assign Automatically is used.
DNS IP Address:
DNS (Domain Name System) server is an Internet service that translates
domain names (ie. www.dlink.com) into IP addresses (ie. 192.168.0.20). The
DNS IP address can be received from your ISP. Enter at least one DNS IP
Address.

Wireless Interface:

Connection Mode:
Use the Connection Mode to determine the type of wireless communication
for the DCS-1000W. There are three choices of Infrastructure mode , 802.11
Adhoc mode and Adhoc mode . The default setting for the Connection Mode
is Infrastructure.
Important Information
16