D-Link DCS-1000W Manual page 26

DateTime:
Select "Synchronized with Time Server" and the time will be based on
GMT setting. The time will be synchronized every 10 minutes. This is also the
default setting for DCS-1000W.
IP Address:
Enter the IP Address of the Time Server in this field.
Protocol:
Two options of NTP or Time are available for your selection to link with the
Time Server. The default setting is NTP.
TimeZone:
System administrator must select the time zone for the region. Please refer to
the appendix for the time zone selection table.
To set the Date Time manually select "Set Manually". The system
administrator must then enter the Date and Time in the respective field
manually.
When you select "Set Manually", each time the DCS-1000W is powered off
and on you must re-enter the details once again due to time lost.
Note:
Please find below NTP server web address for your reference to set the time
server.
http://www.eecis.udel.edu/~mills/ntp/clock1.htm
http://www.eecis.udel.edu/~mills/ntp/clock2.htm
Save/Cancel:
After making sure all settings in the System are correct, click on the "Save"
icon to store the settings in the DCS-1000W. You can alternatively click on
the "Cancel" icon to restore all settings to the values last saved to or retrieved
from the DCS-1000W.
25