LaCie 301161U - Ethernet Disk RAID NAS Server User Manual page 63

LaCie Ethernet Disk RAID
User Manual
Network Settings Options
■
To change this
The IP address(es) used by the Ethernet Disk
RAID
The DHCP settings
(Firmware version 1.4)
Do this
In the Port 1
to obtain the IP address from your DHCP server, or select
address
text boxes.
If your Ethernet Disk RAID has two Ethernet ports and you're using
the second one, do the same in the
does not appear if your system supports only one Ethernet port.)
If you want to use the Ethernet Disk RAID as a DHCP server, in the
Port 1 group box, select
and subnet mask in the subsequent text boxes. Then select the
DHCP server
ing IP address
IP address
For example, if the Starting IP address is 192.168.0.103 and the End-
ing IP address is 192.168.0.107, the Ethernet Disk RAID will al-
locate the IP addresses 192.168.0.103, 192.168.0.104, 192.168.0.105,
192.168.0.106, and 192.168.0.107 to the first five computers that try
to obtain their IP addresses from the Ethernet Disk RAID. As soon as
one of those computers shuts down or otherwise loses its network con-
nection, that IP address will be assigned to the next computer that tries
to obtain its IP address from the Ethernet Disk RAID.
If you do not want to use the Ethernet Disk RAID as a DHCP server,
clear the
automatically is selected, you cannot use the Ethernet Disk RAID as a
DHCP server.)
Managing Your Ethernet Disk RAID
group box, either select Get an IP address automatically
and enter the IP address and subnet mask in the subsequent
Port 2
Use this IP address
check box, enter the beginning IP address in the
text boxes, and enter the last IP address in the
text boxes.
Enable DHCP server check box. (If
page 
Use this IP
group box. (This group box
and enter the IP address
Enable
Start-
Ending
Get an IP address