LaCie 301161U - Ethernet Disk RAID NAS Server User Manual page 120

LaCie Ethernet Disk RAID
User Manual
12. Click Restore
pears. See Fig. 6.9.3.1-B.
13. Specify whether you are recovering to the original
disk or a new disk. If you are recovering to a new
disk, select the desired disk from the list. Then click
Restore.
14. When the confirmation message appears, click Yes.
The backup is recovered to your local disk, and the
progress bar displays the progress of this process.
You can cancel the recovery at any time by clicking
Stop on the progress dialog box.
15. After the recovery is complete, click
your computer.
16. Use the appropriate procedure for your computer to
configure it to boot from the local disk once more.
17. If you changed the recovery password, reset it in the
Microsoft iSCSI Initiator* after your computer re-
starts (as described in section
covery Password in the Microsoft iSCSI
18. Start Windows Backup Software and remove protec-
tion from all your disks and partitions (as described
in section 7.9.5. Removing
them again (as described in section
Your Disks), reusing the existing backups.
If you need to recover other data disks or partitions,
you can do so (as described in section
ing a Data Disk). However, be sure to do this after
you have removed protection and then reprotected
the disks.
19. Disable remote boot (as described in section
Disabling Remote
scribed in section
(Firmware version 1.4)
Disk. The Restore dialog box ap-
OK to restart
8.4. Resetting the Re-
Initiator).
Protection). Then protect
7.2. Protecting
7.9.2. Recover-
Boot) and enable it again (as de-
7.8.1. Enabling Remote Boot).
Fig. 7.9.4.B
ImpOrTANT INfO:
computer, disconnect from the network, or per-
form any other tasks until this process is com-
6.8.2.
Protecting Local Disks
page 
Do not shut down your