LaCie 301161U - Ethernet Disk RAID NAS Server User Manual page 112

LaCie Ethernet Disk RAID
User Manual
mation about your computer and send it to Techni-
cal Support to see if an updated recovery CD or an
appropriate driver is available. To do this, select Save,
insert a formatted floppy disk or USB disk into your
computer, and select the appropriate option
Floppy Disk
has been saved to the specified location, you can send
it to Technical Support. Then select
lect Yes to restart your computer. At this point, you
have 10 seconds to remove the recovery CD from
your CD-ROM drive and boot from your local disk
once more. Otherwise, your computer will boot from
the recovery CD again.
4. When the hardware list appears, take the desired ac-
tion:
Recovery Options
■
To accomplish this
Proceed with recovering data
Load a new recovery driver
See a complete list of the
detected hardware
5. Review the network settings for your NIC and select
Next.
The recovery CD obtains the IP address to use from
your DHCP server. If the displayed settings are not
the ones you want to use, or if no IP address is dis-
played, select the NIC in the list, select Config, spec-
ify the desired IP address, subnet mask, and default
gateway, and select OK.
If multiple NICs are listed, Windows Backup Soft-
ware will use the last operational one (that is, the last
NIC whose Status is Enabled). If you do not want to
use the last listed NIC, select
(Firmware version 1.4)
or Save to USB Disk). Once the file
Finish
Do this
Select Next. You can select
Select Load Driver, select the location from which you want to install the driver
From System for the local hard disk,
From CD for a CD, or
ing from a floppy disk, CD, or USB disk), and respond to the prompts.
Select Diagnostic
Config
(Save to
and se-
Next only if at least one supported NIC is listed.
Load From Floppy Disk
Load From USB Disk
Mode. When you are done viewing the list, select
Protecting Local Disks
for a floppy disk,
for a USB disk), insert the disk (if load-
Normal
page 
(Load
Load
Mode.