Nokia IP2255 - Security Appliance Installation Manual page 108

8
Troubleshooting
Note
You must have local serial access to your appliance console to perform
this procedure.
1. Boot up the appliance in single-user mode by restarting or power cycling
the appliance.
When the
multiuser mode; you have about 10 seconds to do this.
2. After the appliance boots up, the following text appears:
Enter pathname of shell or RETURN for sh:
Press Enter.
3. Type
4. Enter and re-enter the temporary admin password.
5. Enter
6. Enter
7. After the system boots, log on to the security platform by using Network
Voyager or the CLI and set a permanent password.
For information about how to access Network Voyager and the related
reference materials, see
For information about how to access the CLI and the related reference
materials, see
To reset the default database settings
1. Log in to the appliance as admin by using Network Voyager.
For information about how to access Network Voyager and the related
reference materials, see
2. Under Configuration Database Management (Config > System
Configuration > Manage Configuration Sets), choose the option to create
a new factory default configuration.
108
prompt appears, enter
boot
at the pound-sign (
/etc/overpw
to change the password.
y
(Shift + 6 + D) to boot to multiuser mode.
^D
"Using Nokia Network Voyager"
"Using the Command-Line Interface"
"Using Nokia Network Voyager"
Nokia IP2255 Security Platform Installation Guide
before the appliance goes into
-s
prompt.
#)
on page 53.
on page 55.
on page 53.