Nokia IP2255 - Security Appliance Installation Manual page 75

To remove, install, or replace the Nokia encryption accelerator
card
1. Use Network Voyager or the CLI halt command to perform an orderly
2. Identify the location of the NIC or cover plate to remove.
3. Loosen the two retaining screws on the front plate of the NIC.
Caution
4. Press the red button on the ejector and locking lever on the encryption
Nokia IP2255 Security Platform Installation Guide
Removing, Installing, and Replacing the Nokia Encryption Accelerator Card
shutdown of the appliance.
Note
You do not need to turn off power to the security platform.
For information about how to access Network Voyager and the related
reference materials, see
To avoid damage to the ejector and locking lever, loosen the two
retaining screws before you remove any NIC. One screw is located
behind the ejector and locking lever, and the other screw is on the
opposite side of the NIC.
Note
If no NIC is currently installed, remove the two retaining screws on the
blank plate that covers the slot and proceed to
accelerator card.
The lock is released.
"Using Nokia Network Voyager" on page 53.
step 8.
75