System Configuration; Lcd Adjustment - Lexicon DC-1 - REV 1 Owner's Manual

DC-1 Digital Controller
Although the DC-1 memory is cleared before it leaves the factory, it is good
practice to reset the unit before programming it. The following procedure
resets the unit to factory condition:
Turn the DC-1 OFF with either the front panel switch or the remote. Turn
the unit back ON and immediately press BYPASS. (Make sure you do not
block the infrared receiver on the DC-1 front panel.) The display will read:
FACTORY PRESETS MENU
EXIT
RESTORE DEFAULTS
Use MENU or to highlight RESTORE DEFAULTS, then press SELECT.
This will clear and reload all preset effects and all factory settings of
Volume, Balance, Contrast, Configuration, etc. When the message FAC-
TORY DEFAULTS RESTORED is diplayed, press DONE to return to
normal operation.
Depending on the location of the DC-1 in your room, you may need to adjust
the front panel Liquid Crystal Display (LCD) for optimum viewing. To
adjust this display, press the MENU
to enter the Main Menu. Press MENU
Press SELECT to highlight the Display Adjust Menu. Press MENU
select FRONT PANEL DISPLAY.
To adjust LCD contrast, use SELECT to highlight CONTRAST ADJUST-
MENT, and MENU or
as seen from your listening chair. Press DONE twice to return to the main
menu.
If you want to turn the front panel display off, use SELECT to highlight
STATUS, then use MENU
to the main menu.
, or SELECT buttons on the Remote
twice to select DISPLAY ADJUST.
to set the contrast of the display to its maximum
or to select OFF. Press DONE twice to return
Installation and
Calibration
System
Configuration

LCD Adjustment

to
17