Memory System Operation; Memory Storage; Recalling Memories - Yaesu FT-90R Operating Manual

Memory System Operation

The FT-90R includes a versatile Memory system which makes everyday opera-
tion more efficient. The Memory System provides 180 "standard" memories, plus
two pairs of band-limiting memories, and a one-touch "H
band.
For ease in recognition of a channel's function, Alpha-Numeric labels can be ap-
pended to the frequency information.
The discussion below presumes that the function of the microphone's [ VFO/MR ]
button is set to the default "V F O /M R " configuration. If you have used any of M
items 22~26 to assign the "V F O /M R " function to another microphone button or
front panel key, use whatever key you have assigned for the "V F O /M R " function
when the [ VFO/MR ] button is called for in the sections to follow. See page 47 for
details on programming the microphone buttons and front panel keys.

Memory Storage

To store a frequency into memory:
1. In the VFO mode, select the desired frequency, repeater shift, CTCSS tone, TX
power level, and, if this is a packet channel, the desired baud rate (1200/9600).
2. Press and hold in the [ VFO/MR ] button on the microphone for one second. The
display will blink; if a frequency is displayed along with a blinking channel
number, this will indicate that the channel already has frequency data stored on it.
3. Within five seconds of pressing the [ VFO/MR ] button, use the M
or the microphone's [ UP ] / [ DWN ] buttons to select the desired memory channel
for storage. Look for a channel where no data is currently stored, so as not to
over- write channel data you may wish to use.
4. Press the [ VFO/MR ] button again, this time momentarily, to store the displayed
data into the selected memory channel slot. The memory label will stop blink-
ing for a second, then will disappear (since you are still operating in the VFO
mode).

Recalling Memories

From the VFO mode, momentarily press the [ VFO/MR ] button on the micro-
phone to activate the "Memory" mode.
When more than one memory has been stored, use the M
memory for operation. Alternatively, microphone's [ UP ] or [ DWN ] button may be
used to stop or scan through the available memories. When using the microphone's
buttons, press and release the button to move one step up or down; press and hold
the [ UP ] or [ DWN ] button for one second to begin memory scanning.
34
" channel for each
OME
D knob to select a
AIN IAL
FT-90R O
PERATING
ENU
D
knob
AIN IAL
M
ANUAL