Table of Contents
Advertisement
INTRODUCTION
307121/A
The purpose of this manual is the provide the basic information
required to install the Simrad ES200-7CD Split-beam transducer.
Note that although drawings are provided to explain the
installation principles, the manufacturer of the towed body must
provide the final drawings required to fit the transducer.
Transducer order number: KSV-207134.
Caution
The transducer must never be lifted free of the water
surface while the echo sounder is operational.
Transducer installation
The next chapter in this manual provides general guidelines for
transducer installation. The drawings specific for the ES200-7CD
transducer are located in the Drawing file on page 18.
Technical specifications
Refer to the ES200-7CD Product specification.
Connector
The ES200-7CD transducer is fitted with a Burton 8–pin female
connector, type 5501–2008.
Additional parts
The following items can be supplied by Simrad to facilitate
installation:
• Mounting ring: Order number ES2–204464
• Clamping ring: Order number ES2–200879
• Transducer cable (for extension): Order number 642–078215
– Note that this cable is NOT suitable as a tow cable!
The following parts must (if required) be provided by the
installation shipyard:
• Male bulkhead connector: 8–pin Burton 5500 Series
(www.burtonee.com)
Introduction
5
Advertisement
Table of Contents
