Simrad ES200-7 Datasheet

Introduction
The ES 200-7 is a split-beam, composite trans-
ducer with a large bandwidth. This provides a fine
range resolution, which is important for single fish
detection and target strength measurement. The
transducer has four quadrants. The specifications
below are valid when all four quadrants are con-
nected in parallel.
Order number
KSV-202718
Technical specification
Resonant frequency ................................. 200 kHz
Beamwidth, circular ................................ 7 ±1 deg
Directivity:
D ........................................................ 650 ±20 %
DI=10 log D ....................................... 28 ±1 dB
Equivalent two-way beam angle:
y .................................................... .0.009 ±20 %
10 log y .............................................. -21 ±1 dB
Side lobes ..................................... less than -23 dB
Back radiation............................. less than - 40 dB
Angle sensitivity ................................................. 23
Impedance:
Nominal ............................................... 19 ohm
Maximum variation in |Z| ..... 15 to 24 ohm
Maximum variation phase angle ..... ±30 deg
W O R L D W I D E M A N U F A C T U R E R O F M A R I N E E L E C T R O N I C S
Transmitting response .......................... 184 ±2 dB
Receiving sensitivity open circuit ..... -191 ±2 dB
Electroacoustic efficiency ..................... 0.60 ±0.20
Maximum pulse power input .................. 1500 W
Maximum continuous power input ............ 10 W
Maximum transducer depth ........................ 20 m
Cable length .................................................... 20 m
Cable diameter ..................... 17.3 (+0.6, -0.2) mm
Weight without cable ..................................... 3 kg
Storage temperature ......................... -20º to 70º C
(re 1µPa per V)
(re 1V per µPa)