Preparing The Component; Adjustable Fixed Rails - HP 245161-B22 - 10642 42U Rack Shock Pallet Reference Manual

2. Align the rear of the sliding rail with the cage nuts on the rear of the rack and
secure with two M6 × 16 screws.
Figure 4-11: Securing the rear of the sliding rail

Preparing the Component

The following are general instructions for installing a typical rack-mountable
component. See the documentation that was shipped with each component for
complete installation instructions.

Adjustable Fixed Rails

If the component mounts with fixed rails, typically there is nothing additional to
install on the component. The component slides into place along the rails you
installed in the rack.
HP 10000 Series Rack Reference Guide
Installing Components
4-15