Trade-wind S7236CD Installation Instructions & Use & Care Manual

Advertisement

S7200CD Series Models:
No Blower
1200 CFM
S7236CD
S723612CD
S7242CD
S724212CD
S7248CD
S724812CD
S7254CD
N/A
S7260CD
N/A
S7266CD
N/A
S7272CD
N/A
CONTENTS:
Part 1 - Planning The Installation
Part 2 - Electrical Connection
Part 3 - Direction of Vent and Securing The Hood
Direction of Vent and Securing The Hood
Part 4 - Use & Care
Before beginning installation, please thoroughly read and become familiar with these instructions. Installation and
Before beginning installation, please thoroughly read and become familiar with these instructions. Installation and
Before beginning installation, please thoroughly read and become familiar with these instructions. Installation and
service must be completed by a qualified installer. Failure to properly install this product may void the warranty.
Please be advised that the Trade-Wind
area that does not have a roof over the BBQ
Hood should be installed with a MINIMUM of three (3) feet of weather proof roof coverage on all sides that are not
Hood should be installed with a MINIMUM of three (3) feet of weather proof roof coverage on all sides that are not
Hood should be installed with a MINIMUM of three (3) feet of weather proof roof coverage on all sides that are not
protected from direct rain by an adjacent
protected from direct rain by an adjacent wall.
It is required that all duct work and roof o
It is required that all duct work and roof openings be thoroughly sealed with the applicable tape and/or roof sealant
to prevent ingress of water.
Installer:
Please leave Installation Instructions with the
Please leave Installation Instructions with the BBQ hood owner.
Owner:
Please keep Installation Instructions for local electrical
Please keep Installation Instructions for local electrical inspector's use and for future reference.
WARNINGS: Must be followed carefully to avoid personal injury.
IMPORTANT: Must be followed carefully to avoid damage or incorrect installation.
TIPS: Contain helpful information
Contain helpful information to facilitate installation.
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO
WARNING! TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO
PERSONS OBSERVE THE FOLLOWING:
PERSONS OBSERVE THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have any questions, please contact the
a) Use this unit only in the manner intended by the manufacturer. If you have any questions, please contact the
a) Use this unit only in the manner intended by the manufacturer. If you have any questions, please contact the
manufacturer at the address or telephone number listed in the warranty.
manufacturer at the address or telephone number listed in the warranty.
b) Before servicing or cleaning unit, switch power off at service panel and lock service panel and lock the service
b) Before servicing or cleaning unit, switch power off at service p
disconnection means to prevent power from being switch on accidentally. When the service disconnecting means
disconnection means to prevent power from being switch on accidentally. When the service disconnecting means
disconnection means to prevent power from being switch on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device, such as a tag to the service panel.
cannot be locked, securely fasten a prominent warning device, such as a tag to the service panel.
cannot be locked, securely fasten a prominent warning device, such as a tag to the service panel.
Revised 5/19/20
Series Models:
2300CFM
2300CFM
N/A
N/A
N/A
N/A
N/A
/A
S7254
725423CD
S7260
726023CD
S7266
726623CD
S7272
727223CD
qualified installer. Failure to properly install this product may void the warranty.
qualified installer. Failure to properly install this product may void the warranty.
®
®
S7200CD Series BBQ Hood MAY NOT be installed on a Patio or Lanai
BBQ Hood to protect it from direct rain or potential water ingress. This
penings be thoroughly sealed with the applicable tape and/or roof sealant
Must be followed carefully to avoid personal injury.
Must be followed carefully to avoid damage or incorrect installation.
Must be followed carefully to avoid damage or incorrect installation.
READ AND SAVE THESE INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
© 20
© 2020 Trade-Wind Manufacturing, LLC
INSTALLATION INSTRUCTIONS &
INSTALLATION INSTRUCTIONS &
USE & CARE GUIDE
USE & CARE GUIDE
®
Trade-Wind
S7200CD Series
Hood MAY NOT be installed on a Patio or Lanai
m direct rain or potential water ingress. This
inspector's use and for future reference.
anel and lock service panel and lock the service
Series BBQ Hood
Proverbs 22:29
Proverbs 22:29
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S7236CD and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Trade-wind S7236CD

  • Page 1 Failure to properly install this product may void the warranty. ® ® Please be advised that the Trade-Wind S7200CD Series BBQ Hood MAY NOT be installed on a Patio or Lanai Hood MAY NOT be installed on a Patio or Lanai area that does not have a roof over the BBQ BBQ Hood to protect it from direct rain or potential water ingress.
  • Page 2 4. Do not use this unit with any solid-state speed control device. state speed control device. 5. This unit must be grounded. Revised 5/19/20 © 20 © 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Proverbs 22:29 Page 2...
  • Page 3: Planning The Installation

    Ducted fans must always be vented to the outdoors. d) Ducted fans must always be vented to the outdoors. e) For safe and secure wall mounting, the TRADE-WIND ® BBQ Hood should be mounted to e) For safe and secure wall mounting, the Hood should be mounted to a solid vertical surface of sufficient width to allow for mounting of the Hood.
  • Page 4: Front View

    S7242CD S724212CD S7248CD S724812CD FRONTVIEW Model # (No Blower) (No Blower) (2300 CFM) S7254 7254CD S725423CD S7260 7260CD S726023CD S7266 7266CD S726623CD S7272 7272CD S727223CD Revised 5/19/20 © 20 © 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Proverbs 22:29 Page 4...
  • Page 5 Unit is now ready for mounting and installation. Re-install baffle filters as final step after installation is completed. See next page for drawings depicting the unit after conversion. Revised 5/19/20 © 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 5...
  • Page 6: Back View

    (No Blower) (1200 CFM) S7236CD S723612CD S7242CD S724212CD S7248CD S724812CD BACKVIEW Model # (No Blower) (2300 CFM) S7254CD S725423CD S7260CD S726023CD S7266CD S726623CD S7272CD S727223CD Revised 5/19/20 © 20 © 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Proverbs 22:29 Page 6...
  • Page 7: Electrical Connection

    The neutral wire (white) must only be connected to the white neutral wire coming in from the electrical panel. House Electrical House Electrical Panel Green or bare wire White 120V Black (L) Hood Revised 5/19/20 © 20 © 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Proverbs 22:29 Page 7...
  • Page 8 Revised 5/19/20 © 20 © 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Proverbs 22:29 Page 8...
  • Page 9: Warranty

    Some features may be slightly different than shown on product literature. Some features may be slightly different than shown on product literature. ® For more information, please contact your Trade For more information, please contact your Trade-Wind Representative Representative 800 West Grant Street, Phoenix, AZ 85007...
  • Page 10 Revised 5/19/20 © 20 © 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Proverbs 22:29 Page 10...
  • Page 11 ½ of a 10” round duct is 5”. 3.1416 is “Pi”, the “constant” used when calculating the area of a circle. Best Smoke Capture Recommendations Best Smoke Capture Recommendations Revised 5/19/20 © 20 © 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Proverbs 22:29 Page 11...
  • Page 12 *Required dimensions for roof cap - Minimizes static *Required dimensions for roof cap pressure and maximizes air flow to ensure optimum pressure and maximizes air flow to ensure optimum performance of your Trade-Wind product. Wind product. Revised 5/19/20 © 20 ©...

Table of Contents