bouncepad Original Swivel Desk Assembly Instructions

Original Swivel Desk
Assembly Instructions
Tools Required:
Pencil
Electric Drill
Socket Driver
7mm Spanner
*or adjustable spanner
5.0mm Drillbit
*if fixing from below
2.5mm Drillbit
*if fixing from above
16mm *if routing the tablet
cable through your
Holesaw
mounting surface
Sheet Code: BP-OR-IM-040_REV2
Release Date: 13/05/2025
Copyright 2025 SpotSpot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Tighten screw(s) using hand
tools, using electric tools may
damage your Bouncepad.
90˚ limit screw
position
180˚ limit screw
position
Configure the rotation range - both
arrows must be pointing in the same
1
direction. Default configuration is
270˚. Insert 2x Limit Screws.
A
C
A
Mark 'A' positions for "Fixing from above"
A1
(Ø2.5mm drillbit). Mark 'C' for the cable hole.
(Ø20.0mm Holesaw).
Fixings Kit Tablet Set-up Kit
Faceplate
Desk Mounting Arm
Swivel
Pair of Keys
In the Box
2x Limit Screw
Slotted
Driverbit
90˚ limit screw
position
180˚ limit screw
position
Attach the Mounting Arm. The
2
Mounting Arm must forward lean in
the same direction as the two arrows.
A
A
Front
Ø65.5mm
'Mounting Arm Box' includes:
1x Case
Washer
4x M4x16mm
Buttonhead
Screw *
Case
4x M4
Locking
Nut
4x
M4x40mm
Socketset
Screw
'Swivel Box' includes:
4x M4x16mm
Buttonhead Screw
4x M4
Washer
Fixings List
Due to the modular nature of our product range
you may receive additional fixings in the fixings kit.
* Previous models may have been supplied with
20mm.
T20 Pin Torx
Driverbit
4x M4x16mm
Buttonhead
Screw
B
C
Front
B
Mark 'B' positions for "Fixing from below"
B1
(Ø5.0mm drillbit). Mark 'C' for routing the cable
hole. (Ø20.0mm Holesaw).
A
4x M4 Split
Washer
1x T20
Pin Torx
Driver Bit
4x M4
Wing Nut
Minimum Mounting
surface thickness :
Metric
4x No.8
34
Countersunk,
Self Tapping
Screw
2x Limit
Screw
Maximum Mounting
surface thickness :
Metric
1x Slotted
25
Driver Bit
B
Using the hole template (see step A
3
or B), mark the hole positions specific
to your chosen fixing method.
B
B
Follow steps A if "Fixing
from above".
Imperial
1
mm 5/16"
Imperial
1"
mm
Follow steps B if "Fixing
from below".
Drill the
4
required
holes.