bouncepad Original Flex Assembly Instructions

Original Flex
Assembly Instructions
Tools Required:
Pencil
Electric Drill
7mm Spanner
*or adjustable spanner
5.0mm Drillbit
*if fixing from below
2.5mm Drillbit
*if fixing from above
16mm *if routing the tablet
cable through your
Holesaw
mounting surface
Socket Driver
Sheet Code: BP-IM-031_REV4
Release Date: 12/05/2025
Copyright 2025 SpotSpot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Minimum Mounting
surface thickness :
Metric Imperial
34 1
mm 5/16"
Follow steps B if "Fixing
B
from Above".
Mount Washer
4x M4 Split Washer
4x M4 Locking Nut
7mm Spanner
Mount Washer
4x M4 Split Washer
4x M4 Wing Nut
Secure the Flex to the
A4
surface. Locking Nuts
offer higher security.
Tablet Set-up Kit
Fixings Kit
Faceplate
Case
Flex
Mounting
Arm
Pair of Keys
Surface
Mounting Kit
In the Box
Mount Washer
4x Ø5.0mm
1x Ø16.0mm
Front
Using the Mount Washer,
A1
mark the drill hole
locations as shown.
Mount Plate
*see overleaf
Front
A5 B1
Go to step 1.
4x No.8
4x M4x12mm
Countersunk,
Countersunk
Self Tapping
Screw **
Screw
4x M4x40mm 4x M4x16mm
Socketset Buttonhead
Screw Screw *
1x T20 Pin
Torx Driver Bit
8x M4 Split
Washer
1x Mount 1x Case
Washer Washer
Fixings List
Due to the modular nature of our product range you
may receive additional fixings in the fixings kit.
* Previous models may have been supplied with 20mm.
** Previous models may have been supplied with 10mm.
Ø5.0mm Drillbit
Ø16.0mm Holesaw
Drill each hole - using the
A2
specified drill size.
4x Ø2.5mm
1x Ø16.0mm
Using the Mount Plate,
mark the drill hole
locations as shown.
4x M4
Wing Nut
4x M4
Locking
Nut
Maximum Mounting
surface thickness :
Metric Imperial
25 mm 1"
Follow steps A if "Fixing
A
from below".
Tighten screw(s) using hand
tools, using electric tools may
damage your Bouncepad.
4x M4x40mm
Socketset
Screw
Locate & screw the
A3
Socket Screws into one
end of the Flex.
Ø2.5mm Drillbit
Ø16.0mm Holesaw
Drill each hole - using the specified
B2
drill sizes.