StarTech.com CABSHELFHD Quick Start Manual

2U 18in Deep Rack Mount Shelf - 125lb / 56kg
Product Diagram
CABSHELFHD and CABSHELFHD2
1
2
Component
• Used to fasten the Shelf to the Mounting Posts of
1 Front Mounting Brackets
the rack
• Helps prevent the Server Rack Equipment from
2 Front Lip
slidding off the Shelf
3 Shelf Surface • Place Server Rack Equipment
• Helps prevent the Server Rack Equipment from
4 Rear Lip
slidding off the Shelf
Package Contents
• 2U Rack Shelf x 1
• M6 Screws x 8
• M6 Cage Nuts x 8
• M6 Plastic Washers x 8
• Quick-Start Guide x 1
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
4
3
*Product may vary from image
Function
Requirements
For the latest manuals, product information, technical specifications, and declarations
of conformance, please visit:
www.StarTech.com/CABSHELFHD
www.StarTech.com/CABSHELFHD2
• Refer to the manufacturer of the rack to determine the mounting hole type and size
• Phillips head screwdriver
• Cage nut tool (Optional)
Warnings!
Read the entire Quick-Start Guide and ensure the instructions are fully understood
before using this product.
Before adding equipment to this product, ensure this product has been properly
mounted.
Never operate this product if parts are missing or damaged.
Ensure the weight of the equipment does not exceed the weight capacity of this
product. If the weight capacity is exceeded, personal injury or damage to the
equipment is possible. This product can support the following weight: 125 lb (56 kg).
Installation
1. Find a suitable location on the rack to mount the Shelf. The Shelf requires 2U of
Mounting Space.
2. Install the M6 Cage Nuts (x 8) into the Mounting Holes (x 8) on the Mounting
Posts of the rack. If available, use a Cage Nut Tool or your preferred installation
method to install the Cage Nuts.
If the rack has M6 threaded holes, skip this step, as you can use the M6 Screws without
the M6 Cage Nuts.
3. Place the Shelf onto the rack and Align the Mounting Holes of the Front Posts
with the Mounting Holes of the Front Mounting Brackets.
4. Install the M6 Screws (x 8) using a Phillips Head Screwdriver to fasten the Front
Mounting Brackets to the Front Posts of the rack. Ensure the M6 Screws (x 8) are
properly tightened and the Shelf is secure before attempting to place the Server
Rack Equipment.
Quick-Start Guide
Manual Revision: February 14, 2023 7:35 PM