Installing A 5-Ghz Radio Module - Cisco Aironet AIR-AP1200 Hardware Installation Manual

Chapter 8 5-GHz Radio Module Upgrade

Installing a 5-GHz Radio Module

To install a new 5-GHz radio module (RM20A, RM21A, or RM22A) into your access point, follow these
steps:
Before you can install a new 5-GHz radio module, you must remove the access cover or an existing
Step 1
5-GHz radio module (refer to
Module").
Step 2 Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 3 Grasp the new 5-GHz radio module by its base (with the latch opening point down or the antenna
pointing up) and insert the card into the access point's card-bus slot (see
Figure 8-4
1
2
Step 4 Push the 5-GHz radio module into the slot until you hear a slight click.
OL-4310-05
"Removing the 5-GHz Radio Access Cover"
Installing a 5-GHz Radio Module (RM20A or RM21A Shown)
1
Access point
5-GHz radio module antenna
2
3 4
3 Access point card-bus slot
4 5-GHz radio card
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Installing a 5-GHz Radio Module
or "Removing a 5-GHz Radio
Figure 8-4).
8-5