Removing a Blank Spacer Card
Removing a Blank Spacer Card
When your access point is not factory-configured with a 2.4-GHz radio, it contains a blank spacer card
in the internal mini-PCI connector. You must remove the blank spacer card prior to installing a new
2.4-GHz radio card.
Handle all components carefully and observe all ESD precautions. The internal access point components
Caution
and the 2.4-GHz radio can be damaged by ESD from improper handling.
To remove the blank spacer card from the mini-PCI connector, following these steps:
Push the card-retaining clips (on each side of card) away from the card (see
Step 1
the board springs up.
Figure 7-2
1
2
Carefully bend the card near the slots in opposite directions to provide enough clearance to remove the
Step 2
antenna wires.
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
7-4
Location of Retaining Clips on Blank Spacer Card
1
Card-retaining clips
Antenna connector (white wire)
2
3
1
3
Antenna connector (black wire)
Chapter 7
2.4-GHz Radio Upgrade
Figure
7-2). When released,
OL-4310-05