Declaration Of Conformity For Rf Exposure; Guidelines For Operating Cisco Aironet Access Points In Japan; Japanese Translation - Cisco Aironet AIR-AP1200 Hardware Installation Manual

Declaration of Conformity for RF Exposure

Declaration of Conformity for RF Exposure
The radio module has been found to be compliant to the requirements set forth in CFR 47 Sections
2.1091, and 15.247 (b) (4) addressing RF Exposure from radio frequency devices as defined in
Evaluating Compliance with FCC Guidelines for Human Exposure to Radio Frequency Electromagnetic
Fields. For the IEEE 802.11B antennas, AIR-ANT24120, AIR-ANT4121 and AIR-ANT1949 the
equipment should be positioned more than 2 m (6.56 ft) from your body or nearby persons. For all other
approved antennas the equipment shoud be installed more than 20 cm (7.9 in.) from your body or nearby
persons.
The access point (with 5 GHz integrated antenna) must be installed to maintain a minimum 20 cm
(7.9 in.) co-located separation distance from other FCC approved indoor/outdoor antennas used with the
access point. Any antennas or transmitters not approved by the FCC cannot be co-located with the access
point antennas. The access point's co-located 2.4 GHz (2.2 dBi) and 5 GHz integrated antennas support
a minimum separation distance of 10 cm (3.9 in.) and are compliant with the applicable FCC RF
exposure limit when transmitting simultaneously.
Dual antennas used for diversity operation are not considered co-located.
Note

Guidelines for Operating Cisco Aironet Access Points in Japan

This section provides guidelines for avoiding interference when operating Cisco Aironet access points
in Japan. These guidelines are provided in both Japanese and English.

Japanese Translation

Cisco Aironet 1200 Series Access Point Hardware Installation Guide
B-6
03-5549-6500
Appendix B Declarations of Conformity and Regulatory Information
OL-4310-05