Attaching The Compliance Labels - Cisco Aironet AIR-AP1200 Hardware Installation Manual

Chapter 7 2.4-GHz Radio Upgrade

Attaching the Compliance Labels

There are three places on the 1200 series access point dedicated to compliance labels, one for the product
compliance label and two for the radio compliance labels. The label locations are shown in
Figure 7-5
1
2
The product compliance label always occupies the top space (location 1). The two spaces below
(locations 2 and 3) contain the radio compliance labels. Whether or not locations 2 or 3 contain labels
depends on how your access point is configured. For example, a dual-band access point could have two
radio compliance labels (one for each radio device installed), or it could have only a product compliance
label, depending on how it was ordered.
Make sure that your access point has the correct labels after you install or upgrade its radio configuration
so that it will be in compliance with regulations in your country.
OL-4310-05
Access Point Compliance Labels
Product compliance label
Radio compliance label
1
2
3
3 Radio compliance label
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Attaching the Compliance Labels
Figure 7-5.
7-9