Installing A 5-Ghz Radio Module - Cisco 1232AG - Aironet - Wireless Access Point Hardware Installation Manual

Chapter 8 5-GHz Radio Module Upgrade

Installing a 5-GHz Radio Module

To install a new 5-GHz radio module into your access point, follow these steps:
Step 1 Before you can install a new 5-GHz radio module, you must remove the access cover or an existing
5-GHz radio module (refer to
Module").
Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 2
Grasp the new 5-GHz radio module by it's base (with the antenna pointing up) and insert the card into
Step 3
the access point's card-bus slot (see
Figure 8-4
1
2
Push the 5-GHz radio module into the slot until you hear a slight click.
Step 4
OL-4310-01
"Removing the 5-GHz Radio Access Cover"
Installing a 5-GHz Radio Module
1
Access point
5-GHz radio module antenna
Figure 8-4).
2
3 4
3
Access point card-bus slot
4
5-GHz radio card
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Installing a 5-GHz Radio Module
or "Removing a 5-GHz Radio
8-5