Installing A 5-Ghz Radio Module - Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP Hardware Installation Manual

Chapter 5 Upgrading the 5-GHz Radio Module

Installing a 5-GHz Radio Module

To install a new 5-GHz radio module (RM21A or RM22A) into your access point, follow these steps:
Step 1 Before you can install a new 5-GHz radio module, you must remove the access cover or an existing
5-GHz radio module (refer to
Module").
Place the access point on a flat surface so that the unit is upright with the front end facing you.
Step 2
Grasp the new 5-GHz radio module by its base (with the latch opening point down or the antenna
Step 3
pointing up) and insert the card into the access point's card-bus slot (see
Figure 5-4
1
2
Push the 5-GHz radio module into the slot until you hear a slight click.
Step 4
OL-8370-04
"Removing the 5-GHz Radio Access Cover"
Installing a 5-GHz Radio Module (RM20A or RM21A Shown)
1
Access point
5-GHz radio module antenna
2
3 4
3 Access point card-bus slot
4 5-GHz radio card
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
Installing a 5-GHz Radio Module
or "Removing a 5-GHz Radio
Figure 5-4).
5-5