Attaching A Power Adapter; Attaching A Power Adapter Using The Mounting Bracket Air-Accpmk3700 - Cisco Catalyst IW9167I Hardware Installation Manual

Attaching a Power Adapter

1 Access point
2 M6 bolts and washers
Note Ensure that the access point is firmly secured to the mounting bracket.
Never leave the access point unattended if the mounting hardware is not torqued to full value.
Caution

Attaching a Power Adapter

If you want to attach a power adapter (IW-PWRADPT-MFIT4P=) to the access point on a pole using the
mounting bracket AIR-ACCPMK3700= or AIR-ACCPMK3700-2=, use the procedures in the following
sections.

Attaching a Power Adapter Using the Mounting Bracket AIR-ACCPMK3700=

To attach a power adapter (IW-PWRADPT-MFIT4P=) to the access point on a pole using the mounting
bracket AIR-ACCPMK3700=, use the following procedures:
Step 1 Ensure you have the mounting bracket set up as described in Step 1 of
on page 25.
Step 2
Attach the power supply using 4x 6-32 screws and torque the screws to 8.3-11 in-lbs, as shown in the following figure.
Cisco Catalyst IW9167I Heavy Duty Access Point Hardware Installation Guide
30
3 Pole mounting bracket
4 Pole
Using the Mounting Bracket AIR-ACCPMK3700-2=,
Installation Overview