H3C S5500-28C-EI Installation Manual page 83

Installation Manual
H3C S5500-EI Series Ethernet Switches
8) Click Send. The system displays the following page.
Figure 5-6 Page for file sending
9) After the download completes, the system displays the following information:
Loading ...CCCCCCCCCC done!
Note:
You do not need to reset the HyperTerminal's baud rate and thus can skip the last step
if you have chosen 9600 bps. In this case, the system displays the prompt "BootROM is
updating now.....................................done!" instead of the prompt "Your baudrate
should be set to 9600 bps again! Press enter key when ready".
10) Reset HyperTerminal's baud rate to 9600 bps (refer to Step 4 and 5). Then, press
any key as prompted. The system will display the following information to show the
loading process is done.
Bootrom updating.....................................done!
III. Loading host software
1) Select 1 in Boot Menu to load the host software of the switch. The system displays
the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Chapter 5 Boot ROM and Host Software Loading
5-8