H3C S5500-28C-EI Installation Manual page 53

Installation Manual
H3C S5500-EI Series Ethernet Switches
1) Connect one end of the grounding cable to the grounding screw on the rear panel
and the other end to the ground as near as possible.
2) Connect the 12V RPS power connectors.
Figure 3-18 12V RPS power cable
Figure 3-19 12V RPS power connector
Figure 3-20 12V RPS port
a) As shown in Figure 3-20, loosen the fastening screws and remove the RPS
connector cover from the 12V RPS port. (If no 12V RPS power supply is connected,
install the cover.)
3-13
Chapter 3 Installation