H3C S5500-28C-EI Installation Manual page 62

Installation Manual
H3C S5500-EI Series Ethernet Switches
III. Installation procedure
1) Wear an ESD-preventive wrist strap and verify the ESD-preventive wrist strap is
properly grounded. Then take out the XFP interface module from the package.
2) Loosen the mounting screws of the blank panel on the read panel of the switch
with a screwdriver and remove the blank panel.
3) Hold the fastening screws on the front panel of the XFP interface module, and
gently push the XFP interface module in along the guide rails until the XFP
interface module is in close contact with the switch.
(1) Switch
(3) XFP interface module
Figure 3-35 Install a 10 GE XFP interface module
Step 4: Tighten the fastening screws with a screwdriver to fix the XFP interface module.
Note:
Put away the removed blank panel for future use.
When tightening the fastening screws at both sides of an optional interface module
with a screwdriver or an electric screwdriver, make sure that the torque is not bigger
than 0.4 N.m.
IV. Removal procedure
1) Put on an ESD-preventive wrist strap and verify the ESD-preventive wrist strap is
properly grounded.
(2) Optional module slot
(4) Push-in direction
3-22
Chapter 3 Installation