Table of Contents
Advertisement
If your servo does not operate, it intermittently stops operating, or it operates
erroneously, take the action shown in the table below. If this does not correct the trouble,
please contact a Futaba dealer.
Check point
Battery
Connecter
Servo horn
Command
Cable
Before requesting repair, read this instruction manual again and recheck your system.
Should the problem continue, request repair service as follows:
Describe the problem in as much detail as possible and send it with a detailed packing
list together with the parts that require service.
_Symptom (Including when the problem occurred)
_System(Application configuration)
_Model Numbers and Quantity
_Your Name, Address, e-mail address, and Telephone Number.
If you have any questions regarding this product, please consult your local Futaba dealer.
TROUBLESHOOTING
Table 0-1 Check list
Check item
Dead battery.
Incorrect loading voltage.
Faulty contact connection.
Dirty contacts.
Looseness of screws
ID, baud rate, check sum
Short-circuit
Replace the battery.
Charge the LiPo battery.
Reload the batteries in the correct polarity.
Change the recommanded battery
If the contact pin is deformed, correct it.
Wipe with a dry cloth
Fasten the screws
Conform the command packet rules
Change the cable
32
Action
Advertisement
Table of Contents
