Steering Speed - FUTABA 3GR-2.4GHZ Instruction Manual

Quick steering operation will cause momentary understeering, loss of speed, or spin-
ning. This function is effective in such cases.
Understeering
Operation
- This function limits the maximum speed of
the steering servo. (Delay function)
- The steering speed when the steering stick
is operated (TN direction) and returned (RN
direction) can be independently set.
- If the steering wheel is turned
slower than the set speed, the steer-
ing servo is not affected.
Calling the setup screen
(Initial screen)
Press "SEL" key to select the
desired function screen.
Steering Speed (SPD) adjustment
(Preparation)
- Select setup item "SPD-TN" and make the following
adjustments:
1
"TN" direction adjustment
Use the (+) and (-) buttons to adjust the delay
amount.
2
"RN" direction adjustment
Select setup item "SPD-RN" and use the (+)
and (-) buttons to adjust the delay amount.
3
When ending adjustment, return to the initial
screen by pressing the (SEL) button.
Steering Speed/SPD
Steering speed not set
(Setup screen)
Setup item
SPD-TN: TURN direction
SPD-RN: RETURN direction
Spin
Steering speed set
TN direction
Turning speed adjustment range
Press "CH" key to select the next set-
up screen.
Adjustment range
0~100% (each direction)
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Return to the initial value by pressing
the (+) and (-) buttons simultaneously
(approx. 1 sec).
Setting range: 1~100%
At 100%, there is no delay.
At 1%, the delay is approximately 1.5
seconds.
100%
Servo operation is delayed.
Smooth cornering
"TURN"
1.5 0.1
RN direction
"RETN"
Return speed adjust-
ment range
1.5 0.1
Time
1%
33