Corded Buttonhole - ELNA 5200 Instruction Manual

q
z x
q
c v
b n
w e
w
e

Corded Buttonhole

Machine Settings
q Pattern:
w Presser foot:
e Thread tension dial: 1-5
To sew a corded buttonhole, follow the same
procedure as for a square buttonhole.
z With the automatic buttonhole foot R raised, hook
the filler cord on the spur q on the back of the
buttonhole foot.
x Bring the ends of cord toward you under the
buttonhole foot clearing the front end.
Hook the ends of the filler cord e into the forks w
on the front of the buttonhole foot to hold them
tight.
c Lower the needle into the garment where the
buttonhole will start and lower the foot.
v Lower the buttonhole lever and buttonhole foot.
Start the machine and sew the buttonhole over the
filler cord.
The machine stops automatically when finished.
NOTES:
Set the stitch width in accordance with the thickness
of the filler cord used.
To cut the buttonhole opening, refer to page 56.
b Remove the fabric from the machine and cut the
sewing threads.
n Pull the left end of the filler cord to tighten it.
Thread the end of the cord through a darning
needle and draw it to the wrong side of the fabric
and cut.
64
#16
Automatic buttonhole foot R