Winding The Bobbin; Removing The Bobbin; Setting The Spool Of Thread; Additional Spool Pin - ELNA 5200 Instruction Manual

q
w
q
w
e
y
r
t
z
u
x
i
v
e
x
c
b

Winding the Bobbin

Removing the bobbin

To remove bobbin, slide bobbin cover plate release
button q to the right and lift away the bobbin cover
plate w.
Lift out the bobbin e.
Turn ON the power switch.
Always use bobbin type supplied with machine.

Setting the spool of thread

Lift up the spool pin. Place the spool of thread on the
spool pin with the thread coming off the spool as
shown.
Attach the large spool holder q, and press it firmly
against the spool of thread.
Use the small spool holder w to hold narrow or small
spools of thread.

Additional spool pin

Use the additional spool pin for winding a bobbin
without unthreading the machine. The additional spool
pin is also for twin needle sewing.
Insert the additional spool pin e into the spool stand
y and then into the hole t in the machine.
Place the felt r on the spool pin and place a spool of
thread on it as shown.

Threading for bobbin winding

z Set the speed control lever at
Guide the thread around the thread guide u.
x Pass the thread through the hole in the bobbin
from the inside to the outside. Place the bobbin on
the bobbin winder spindle i.
c Push the bobbin winder spindle to the right.
The indicator will show
v Hold the free end of the thread in your hand and
depress the foot control.
Stop the machine after the bobbin has spun
several times, and cut the thread close to the hole
in the bobbin.
b Depress the foot control again. When the bobbin
is fully wound, it will stop automatically.
Release the foot control and return the bobbin
winder spindle to its original position by moving it
to the left, and cut the thread with a pair of
scissors. Remove the bobbin from the bobbin
winder spindle.
NOTE:
The machine will not sew until the spindle has been
returned to the left.
22
.
.