How To Drop The Feed Dog; Attaching And Removing Presser Foot; Attaching And Removing Shank - ELNA 5200 Instruction Manual

q
q
w
w
r
q
w
q
w
q
e
r
e
w
e

How to Drop the Feed Dog

The feed dog can be dropped out of position for
special sewing techniques: free motion embroidery,
stippling, button sewing, etc.
Locate the feed dog lever on the back of the machine.
Slide the lever either to the right (down) q or to the
left (up) w. To bring up the feed dog e, hand turn the
flywheel r after sliding lever to the left.
NOTE:
The feed dog should be in the up position for regular
sewing. Turn the flywheel toward you to check if the
feed dog comes up after setting the lever in the up
position.

Attaching and Removing Presser Foot

Press the Up/Down Needle key until the needle
is in the raised position.
Turn OFF the power switch. Raise the presser foot
and press the lever q on back of the shank.
The presser foot will drop off.
Place the selected presser foot so the pin e on
the foot lies just under the groove w of the shank.
Lower the presser bar and attach the foot.
Each foot is marked with a letter for identification

Attaching and Removing Shank

Turn OFF the power switch.
Raise the presser bar.
Turn the setscrew q counterclockwise with the
screw key to remove the shank.
To attach, match the hole in the shank w with the hole
in the presser bar e. Put thumbscrew in hole and turn
clockwise to tighten.
14
r .