Table rallonge (boîte de rengement d'accessoires) et
bras libre ................................................................ 5
SECTION II. PRÉPARATION DES TRAVAUX DE
COUTURE
Branchement de la machine sur l'alimentation
électrique ............................................................... 7
Pédale ....................................................................... 9
Touche Mode ........................................................... 13
Point droit ................................................................ 31
Fronces ................................................................... 39
Point zigzag ............................................................. 45
TABLE DES MATIÈRES
Reprises .................................................................. 69
Faufilures ................................................................. 71
Point coquille ........................................................... 75
Points passés .......................................................... 75
Appliqués ................................................................ 77
Patchwork ............................................................... 77
INDEX ..................................................................... 91
REMARQUE: Les informations données dans ce
manuel d'utilisation sont d'actualité au moment de la
mise sous presse. Nous nous réservons le droit de
mettre à jour et de modifier ces informations et les
caractéristiques techniques de la machine le cas
échéant.
Need help?
Do you have a question about the 5200 and is the answer not in the manual?
Questions and answers
How to adjust width and length of zigzag stitch on 5200 Elna?
To adjust the width and length of the zigzag stitch on the ELNA 5200:
1. Activate stitch width mode by pressing the mode key. The stitch width can then be adjusted between 0.0 and 7.0 using the plus or minus keys.
2. To adjust stitch length, press the mode key again to switch to stitch length adjustment (the middle green light turns on). The preset value is "5.0", and it can be changed using the plus or minus keys.
This answer is automatically generated
How to thread the bobbin