Section Iv. Points Décoratifs; Point Coquille; Points Passés; Bogensaum - ELNA 5200 Instruction Manual

Hide thumbs Also See for 5200:
Table of Contents

Advertisement

SECTION IV. POINTS DÉCORATIFS

Point coquille

Réglages de la machine
q Motif :
w Pied presseur :
e Tension du fil d'aiguille: 6-8
C'est une jolie finition d'ourlet pour la lingerie et les tricots.
Vous pouvez réaliser des points coquille dans n'importe
quelle direction sur les tricots ou les tissages soyeux
souples.
Utiliser un tissu fin. Plier le tissu et piquer dans le biais.
Laisser l'aiguille dépasser légèrement du bord plié
lorsqu'elle va vers la droite du tissu.
Si vous cousez plusieurs rangs de points coquille, espacez-
les d'au moins 1,5 cm.
Points passés
Réglages de la machine
q Motif :
w Pied presseur :
e Tension du fil d'aiguille : 1-4
Pour obtenir de meilleurs résultats, un entoilage doit être
utilisé sur l'envers du tissu lorsque l'on travaille sur des
étoffes extensibles ou élastiques.
Appuyer sur la touche d'arrêt automatique pendant la
couture du dernier motif. La machine s'arrêtera
automatiquement après avoir terminé le dernier motif.
N° 15
Pied pour point passé F
N° 24 à 27
Pied pour point passé F
ABSCHNITT IV. ZIERSTICHE

Bogensaum

Maschineneinstellungen
q Muster:
w Nähfuß:
e Oberfadenspannung:
Dies ist ein hübscher Saum für Unterwäsche und
Trikotstoffe. Bogenstiche können auf Wirkware oder weichen
Seidenstoffen in beliebiger Richtung genäht werden.
Benutzen Sie einen leichten Stoff. Falten Sie den Stoff
diagonal und nähen Sie.
Achten Sie darauf, dass die Nadel gerade die Kante der
Falte durchsticht, wenn die Nadel nach rechts ausschlägt.
Sollen Bogenstiche in Reihen genäht werden, wahren Sie
einen Abstand von mindestens 1,5 cm zwischen den
Reihen.

Federstiche

Maschineneinstellungen
q Muster:
w Nähfuß:
e Oberfadenspannung:
Bessere Nähergebnisse werden erzielt, wenn Stretchstoffe
auf der linken Seite mit Einlagen verstärkt werden.
Drücken Sie beim Nähen des letzten Musters die Auto-
Verriegelungs-Taste. So hält die Maschine automatisch an,
wenn das letzte Muster fertig genäht ist.
75
#15
Federstichfuß F
6-8
#24 bis #27
Federstichfuß F
1-4

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 5200 and is the answer not in the manual?

Questions and answers

Mary Selph
April 10, 2025

How to adjust width and length of zigzag stitch on 5200 Elna?

1 comments:
Mr. Anderson
April 10, 2025

To adjust the width and length of the zigzag stitch on the ELNA 5200:

1. Activate stitch width mode by pressing the mode key. The stitch width can then be adjusted between 0.0 and 7.0 using the plus or minus keys.
2. To adjust stitch length, press the mode key again to switch to stitch length adjustment (the middle green light turns on). The preset value is "5.0", and it can be changed using the plus or minus keys.

This answer is automatically generated

Brenda Hooper
April 20, 2025

How to thread the bobbin

Subscribe to Our Youtube Channel

This manual is also suitable for:

Experience 540Experience 540 sExperience 520 s

Table of Contents

Save PDF