Wacom CINTIQ 12WX - OTHER User Manual page 44

12WX_Manual.fm Page 40 Thursday, September 13, 2007 3:38 PM
An "invalid mode" message
briefly appears on your display
screen.
The image appears multiple
times on the display.
When a still image is displayed
for a long period of time without
refreshing the screen, an after-
image remains for a short
period of time.
Color quality is inaccurate.
The color white does not
display as white.
Troubleshooting
Page 40
•
The input signal frequency is incorrectly set or not compatible
with Cintiq. Set the refresh rate (vertical frequency) to 60 Hz
(or between 56 and 75 Hz if you are using a resolution of less
than 1280 x 800 pixels). If your video card driver supports
adjustment of the horizontal frequency, make sure it is set to
some value between 31 and 82 kHz. On a single display
system you will need to connect a different display to change
the refresh rate.
•
The resolution is set too high (1280 x 800, maximum).
•
Set the display properties to detect plug and play displays.
•
Do not extend the video cable. Do not use an input selector
switch box.
•
Use a screen saver or other power management feature.
•
Open the OSD menu, go to the R
F R option.
ACTORY ESET
•
Be sure the Cintiq color profile has been installed and is
selected as the profile for use with your operating system and
applications.
•
Any changes to the contrast setting should be made in small
increments as changes in contrast may affect color accuracy.
•
Be sure the Cintiq color profile has been installed and is
selected as the profile for use with your operating system and
applications.
•
Verify also that the display is operating at the factory default
settings. If that is not sufficient, then adjust color as
necessary. For details on color management, see your
operating system and application documentation.
•
Verify that the video cable is fully connected.
menu, and select the
ESET