Attaching To Other Tm Printers - Epson B113111 - DM D500 - Vacuum Fluorescent Display Character Installation Manual

English
8. Place the TM printer on the fixing plate. (See the table below for
the mounting position for each TM printer.)
Printer type
TM-T88II
TM-U210/U230/T90/L90
Note:
Place the TM-U230 printer as shown in
illustration 52. (Do not place it vertically.)
9. Connect the power supply to the TM
printer.
Assembling using screws
1. Follow steps 1 to 4 in "Assembling using
Velcro tapes."
2. Secure the fixing plate where you want it
with the fixing screws as shown in
illustration 53.
3. Follow steps 7 to 9 in "Assembling using
Velcro tapes."

Attaching to Other TM Printers

When using with other TM printers, the DM-D500 can be attached
to a desk or other surface using the "DM-D pole unit for TM
printers (Type A)" (DP-502) and screws or Velcro tapes.
18 DM-D500 Installation Guide
Mounting positions for TM printers
Set the printer so that no rubber foot on the rear side of the
printer is placed on the Velcro tape.
Set the printer so that no rubber foot on the rear side of the
printer is placed on the Velcro tape.
Set the printer so that the iron plate on the rear side of the
printer is placed on the Velcro tapes.
52
53