Table of Contents
Advertisement
English
2. Remove the DIP switch cover as shown in illustration 79.
3. Change each setting of the switches with a pointed object, such
as a pen tip or small screwdriver.
4. Close the cover, and turn the power on.
Turning and Tilting the DM-D500
You can turn or tilt the display while holding the support. The
display can be moved easily, so do not move it any further if it
stops. If you move it by force, you may damage it.
With the "DM-D pole unit for IR" (DP-504) and the "DM-D pole
unit for TM printers (Type B)" (DP-503), the display area may not
face the direction you desire. In this case, remove the base, change
the position of the tab on the base so that the display faces in the
direction you desire, and reattach it to the base as shown in
illustration 80.
48
80
The display area has the following range of movement:
Tilt: 48 max. (4 steps, 5 positions)
Horizontal rotation: 90 max. (45 for each left and right)
30 DM-D500 Installation Guide
79
DIP switch cover
45 for left
(you can turn the
same angle for right)
Advertisement
Table of Contents
