Epson B113111 - DM D500 - Vacuum Fluorescent Display Character Installation Manual page 27

5. If using the unit as a standalone, go to step 6. When using the
DM stand with the printer, connect one end of the printer
interface cable for the printer to the printer connector on the
DM-D stand; then connect the other end to the connector on the
printer as shown in illustration 73. Tighten the screws on both
ends of the cable to fasten them.
73
printer
6. If not using the extension cable packed with the DM-D stand
for power supply, go to step 7. When using the extension cable,
connect it (with the arrow mark up) to the extension cable
connector indicated with "POWER OUT" on the DM-D stand;
then connect the other end to the power connector on the
printer as shown in illustration 74.
extension cable
connector
74
extension cable
for power supply
DM-D500 Installation Guide 25
English