Table of Contents
Advertisement
English
Connectors for the DM-D stand
The connectors for the DM-D stand are shown in illustration 65.
computer connector
65
Note:
The DM-D stand comes with inch-type hexagonal lock screws installed to
secure the interface cable to the interface connector for the RS-232C. If
you plan to use an interface cable that requires millimeter-type lock
screws, replace the inch-type screws with the included millimeter-type
screws using a hex screwdriver (5 mm {0.2"}). To distinguish the two
types of screws, see illustration 66.
notch (one or more lines)
66
Jumper settings
Set the jumpers on the DM-D stand as follows:
JP1
JP2
Contents
1-2
1-2
When connecting both the TM printer and the DM-D stand. (Default setting.)
2-3
2-3
When using the DM-D stand as a standalone. (TM printer is not connected.)
22 DM-D500 Installation Guide
display connector
power supply unit connector
inch-type
millimeter-type
printer connector
extension cable connector
RS-232C connector
installation screw
Advertisement
Table of Contents
