Chapter 5 Connect To A Network; Procedures; Connect Over Ethernet; Connect Over Wireless (802.11 B/G) - Cisco DMS-DMP-4300G User Manual

Procedures

Procedures
•
•

Connect Over Ethernet

Before You Begin
•
•
Procedure
Step 1
Plug one end of a standard Ethernet cable into the corresponding socket on your DMP.
Step 2
Plug the other end of this cable into a network hub, network switch, or router whose network uses DHCP
to allocate IP addresses dynamically.
Step 3
Stop. You have completed this procedure.
Related Topics
•
•

Connect Over Wireless (802.11 b/g)

Note
You can configure wireless network settings during a later phase of DMP setup, if your DMP supports
this feature. However, there are other tasks that you must finish first. When you are ready to configure
wireless settings, these topics say how.
•
•
User Guide for Cisco Digital Media Player Device Manager 5.2.x
5-2
Connect Over Ethernet, page 5-2
Connect Over Wireless (802.11 b/g), page 5-2
Does a security policy in your network restrict DHCP address assignments to known MAC
addresses? If so, locate the MAC address printed on a sticker that is affixed to your DMP. Then,
share this address with your security policy administrator.
Does your DMP support wireless networking? If so, consider whether you might prefer to use that
method instead of this one.
Physical Interfaces (I/O Ports), page 2-4
Connect Over Wireless (802.11 b/g), page 2
Connect Over Wireless (802.11 b/g), page 5-2
Assign a Static IP Address to a Wireless DMP 4400G, page 11-16
Chapter 5 Connect to a Network
OL-15764-03