Receive Electrical Power From 802.3Af Power Over Ethernet (Poe) - Cisco DMS-DMP-4300G User Manual

Chapter 4 Connect to a Power Source

Receive Electrical Power from 802.3af Power over Ethernet (PoE)

Note •
•
•
Procedure
Step 1
Use the On/Off power button on the DMP chassis to verify that your DMP is turned Off.
Step 2
Connect a standard, Category 5 Ethernet cable to your DMP.
Step 3
Attach the other end of the Ethernet cable to a PoE-enabled network switch that operates inside
your network.
Step 4
Use the On/Off power switch on the DMP chassis to turn your DMP On.
Step 5
Stop. You have completed this procedure.
Related Topics
•
•
•
OL-15764-03
You can power a DMP 4310G through its Ethernet cable. Other DMP models do not support this feature.
A DMP 4310G has two USB interfaces on its chassis. When you use PoE to power a DMP 4310G, we recommend that
you use no more than one of these USB interfaces at a time. IEEE 802.3af PoE is limited in its capacity and might not be
sufficient to power your DMP and two USB peripherals simultaneously.
When both PoE power and AC power are detected, AC power overrides PoE and disconnects the PoE circuit.
Physical Interfaces (I/O Ports), page 2-4
Power Cord Options, page 2-6
Receive Electrical Power from a 100V–240V AC Socket, page 4-2
User Guide for Cisco Digital Media Player Device Manager 5.2.x
Procedures
4-3