WisyCom MTH610 Quick User Manual

MTH610
Main Accesories
(find more information at Wisycom.com )
MTH-RING:
kit of colored rings for MTH610
CAUSBM5P:
Magnetic cable 5 pin-M + USB-C
Conformity
Conformity identification is visible on the display by accessing from the Main menu the Info> STD
submenus:
step 1: access submenu Info;
step 2: access submenu STD.
RADIO Directive 2014/53/
EU Radio Equipment
Directive (RED)
UK Conformity
(*)The Wisycom microphone handheld transmitter model MTH610 complies with the following requirements: FCC (Federal Communications Commission) Part
74. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operations.
Changes or modification not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC ID can
be found inside the battery compartment.
This device complies with part 15 of the fcc rules. operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.Note: the grantee is not responsible for any
changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
(**) EN This device complies with Industry Canada license-exempt RSS-123 and RSS-210 standard. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
This radio transmitter IC: 11967A-MTH610 has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissi-
ble gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain
indicated for that type, are strictly prohibited for use with this device.
FR Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence RSS-123 et RSS-210. L'exploitation
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage ra-
dioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Le présent émetteur radio IC: 11967A-MTH610a été approuvé
par Industrie Canada pour fonctionner avec les types d'antenne é numérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour
chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour
l'exploitation de l'émetteur.
This equipment complies has been evaluated for and shown compliant with the FCC and ISED RF Exposure limits. The unit of measurement for RF exposure
is Specific Absorption Rate (SAR). The FCC SAR limits for is 1.6W/Kg per 1g of tissue.The maximum SAR levels tested has been shown to be 0.133 W/kg at
head with 0mm of separation distance from the body.
This device operates on a no-interference, no-protection basis. Should the user seek to obtain protection from other radio services operating in the same TV
bands, a radio license is required. For further details, consult Innovation, Science and Economic development Canada's Client Procedures Circular CPC-2-1-
28, Voluntary Licensing of License-Exempt Wireless Microphones in TV Bands.
QUICK USER GUIDE
PTM610:
Push to talk accessory for
MTH610 with switch for MUTE (ON/OFF)
and a button for PTT - Height 30mm
MTH-LB-ACC:
Spacer for 14430 Li-ion batteries
FCC-ID: POUMTH610 *
IC
IC: 11967A-MTH610 **
This guide is intended to assist you with initial quick setup and
operation for your Wisycom product.
You can refer to Wisycom Autorized Distributors for technical
Support and information about service and repairs available in your
area or contact us directly by email.
WISYCOM S.r.l.
Via Tiepolo 7/E
35019 Tombolo (PD) - ITALY
+39 0424 382605
support@wisycom.com
sales@wisycom.com
Download Documentation and Firmware
Get declarations, user manual, specifica-
tions and softwares on the download page:
wisycom.com/products/d/mth610/
Product Registration and Warranty
Register your product to extend your warranty
and receive update on latest firmware:
wisycom.com/registration
Keep up with Wisycom online
Follow us on Facebook and Instagram. You
can also subscribe on Youtube for more.
wisycom.com/social
MTH610
QUICK USER GUIDE