To Secure/Level The Saw; To Store The Table Saw Accessories - Craftsman 21829 - Professional 10 in. Portable Table Saw Operator's Manual

TOSECURE/LEVEL THESAW
See F-igum9.
With the leg stand open and the table saw resting on a
fiat, level surface, the saw shou]d not move or rook fl'om
side to side.
ff the sew rests on the wheels and roils, [oosaneach
wheel stop by turning counterclockwise.The leg stand
should met on each stop only slightly.If the wheel stop is
turned too much, the stop will interferewith the opening
and closing motion of the leg stand.
if the saw rocks from side to side, the levelingfeet need
adiustlng until the leg stand is balanced.
• Loosen both the top and bottomwing nuts.
• Lift the saw slightlyso that you may turn the kiveiin9
foot untilthe leg stand no longerrocks.
• Turning ctookwise wilt lower thefoot
•Turning countarclockwisaw_llra'lsathe fog
WINGNUT
FOOT
Fig. g
TO S'fORE THE TABLE SAW ACCESSORIES
See Figures 10. - 11
The table saw has two convenientstorage areas specifi-
cally designed for the saw's accessories. These accesso-
ries must be sooure_ystored priorto closing the leg stand
and moving the saw.
The rip fence, miter fence, and miter gauge shouldbe
stored in the brackets located on the side of the saw
cabinet. Simply snap each accessoryin place to hold _t
securely.
Storage hooks for the slidingmiter table are located on
the back of the saw cabinet. This storagearea is to be
used onlyfor moving the saw or when the saw is not
being used.
NOTE: During operation of the saw, the slidingmiter table
must be mounted on the mile. NEVER operate the sew
with the sliding miter table in the storage position because
it blocksthe dust exhaust port.
MZTER
RIPFENCE
Fig. 10
Stand facing the back of the table saw. The longest part of
the miter table base must be stored to the left. To secure
the sliding miter table:
• Restthe slidingmiter table on the bottom right-hand
storage hook and +,he miter base on the lower miter
bottom left-hand hook.
I Alignthe bottom miter lookingcfe_np with the bottom
left storage hock. Push the slidingm'rter table back
toward the cabinet _zntil i t is restingagainst all four
hooks.
• Look the miter lookingclamps on the left by pushing
clamps toward the side of the oabinst securingthe
miter table in place.
MI'IER
STORAGE
HOOK
SLIDING
MITER
TABLE
STOP, ABEHDDK
F_g;11
17