Making A Compound Miter Cut - Craftsman 21829 - Professional 10 in. Portable Table Saw Operator's Manual

= When the out la made, turn the saw off. Wait for the
blade to come to a complete stop before removingthe
workplace.
• After the blade has stopped oomplateiy, remove the
cutoff stock.
• Grasp the workplece from the lead end (the and fed
into the b{ade first) and carefully remove it from the
table.
BEVEL. RiP CUT
8LADE
ANGLED
SCALE
\
• Loosen the lock knob on the miter gauge, set the miter
gaugeto the desired angle and tighten lock knob.
• Turnthe power switch to the ON position.
• Positionthe workpiece fiat on the table with the edge
flushagainst the miter gauge. Let the blade build up to
full speed before feeding the workplace Into the blade.
• Advance the workplace and the miter gauge toward
the blade. Keep the workpiece flushagainst the miter
gauge. Push the miter gauge and workplace toward
the blade. Stand slightlyto the side of the wood as
it contacts the blade to reduos the chance of injury
should kickback occur.
II When the out Is made, turn the saw off. Wait for the
blade to come to a complete stop beforeremovingthe
workplace.
• After the blade has stopped completely,remove the
cutoff stock.
COMPOUND (BEVEL) MITERCUT
PL_ RIGHT HAND
ONWORKPIECE AND
MR'ER GAUGE HERE
Fig. 46
MAKING A COMPOUND (BEVEL) MITER CUT
See Figure 47.
It is recommended that you place the piece to be saved
on the left side of the blade and that you make a test cut
on scrap wood firsL
_1, WARNING: Make sure the blade guard ass_"nbly
is installedand working propedy to avoid sadoue
posaibla i njury.
• Remove the rip fence by liftingthe lock down handle,
• Unlock:he bevel locking lever.
• Adjust the bevel angle to the desired setting.
• Lock the bevel locking lever.
• Set the saw blade to the correct depth.
34