Table of Contents
Advertisement
,_
WARNING:
Never feed wood with your handswhen
ma_dngany non-throughcut such as rabbets or
dadoes. To avoid personal injury, aJways use push
blocks, push sticks, and featherboards.
• When the cut is made, turn the saw OFF. Wait for the
blade to come to a complete stop before removingthe
workpieca.
• Unplug the saw.
• Lower the blade and remove the screw holding the
throat plate in place. Remove the throat plate.
• Raise the saw b(ade.
• Push the bevei lockingleveeto the right.Rotate the height
adjustinghandwheelunUi the bevelindicatorshowsa 30+
angle. Push the bevel Iocldng leveesecurelyto the left
while holdingthe height adjustinghandwheelto lock the
angle. Reinsta_the b_adeguard assembly.
• Retighten the nuts at the base of the riving knife.Check
riving kni_'e alignment to the blade and adjust shims if
necessary.
• Move the bevel locking [everto the right and rotate the
blade back to 90% Push the leverto the left to lock the
angle.
• Lower the blade, insert the throat plate, then securely
tighten the throat plate screw.
NON-THROUGHCUT
BLADE
GUARD
REMOVED
MAKING A DADO CUT
See _gurs 50.
An optior_l _Lado throat plate _sreq_drsdfor this pro-
cadurs (max. dado wirtth _3/16 in.). See the Accessorles
sectionof this manua! and check with your nearest Sears
retsil. Do not use blades rated less than the speed of this
tooL
NOTE: This saw cannot be used to make a bevel dado
CUt.
•
Unplug the saw.
• Remove the blade guard aseembly.
•
Ratlghtanthe two hex nuts.
•
Remove the saw blade.
•
Remove _he inner blade washer and both the sma_ and
_eege spacers.
• Add the smell spacer then the inner b]ade washer to
the bladesarbor.
• Mount the dado blade, usingthe blade and chippers
appropriatefor the desired width of cut.
• Reinstallthe arbor nut.
• Make sure the arbor nut Is fullyengaged and the
eebor extends at loast one fiJll_rsad past a sacurely
tightened arbor nut.
_k
WARNING;
Always put all spacers in proper
locationwhen changingback to saw blade. Failure
to do so may resultin possible injuryand damage to
the tool.
A
WARNING: Akvays use push blocks, push stlc_, or
fsatharbcardswhen making dado cuts to avoid the
risk of serious injury.
9J_l}0 CUT
PUSH
STICK
Fig. 4g
• 36
F_g.50
Hide quick links:
Advertisement
Table of Contents
