Maintenance; Locker Bracket Assembly; Tilt/Elevating Mechanism - Craftsman 21829 - Professional 10 in. Portable Table Saw Operator's Manual

A
Am, WARNING: When servicing, use only identice_
repianementpaps. Use of any other parts m_y create
a hazardorcause product damage.
A
Am. WARNING: A_vays wear safety goggles or safety
glasses with side shietdsduringpower too_opera,on
or when blowing dust. If operation is dusty,also wear
a dust mask.
GENERAL
Avoid using so(ventswhen cteaning p_,stioparts. Most
plasticsare suscsptibteto damage from various types of
commercial solventsend may be damaged by their use.
Use clean clothsto remove dirt, dust, o11, grease, etc.
_1_ WARNING: Do not at any Limelet brake fluids,
gaso(ine,petro(eum-basedproducts, penetrating
oils, etc., come In ¢on_actwith pta_'=o parts.
Chemicatscan damage, weaken, or destroyp_stic
which may resuttIn serious personalinjury.
• Periodicallycheck all clamps, nuts, boits, screws, and
_{ts _ar t_hl.r_ss and cond_,_n, Make sure the t_roat
p_te is (ngood cond(t(on a.nd_. position.
• Check the blade guard assembty.
• To maintain the t_bte sur_css, fence, and raits,
pedodice]Iyapply paste wax to them and buff to
providesmooth functioning. To preventwork from
slipping duringcutting operation,Do not wax the
working face of the miter fence.
• Protect the bb.de by cleaningout saw dust from
underneath the _b(e and in the b{ade teeth. Use a
reamsolvent on _heb_ade teeth.
• Clean plastio parts only with a soft damp cloth. Do
not use any aerosol or petroleumsolvents.
LUBRICATION
This saw has been lubricated at the factory priorto ship-
ment. Foflowingextended use, you should inspectand
lubricate the following areasto assure smooth operation.
LOCKER BRACKET ASSEMBLY
See Figure69.
• Add dry lube between both bevel gears, theb_ckup
washers,and the locker braoket..
• Adddrylubs be_:weenthreaded hole in motor casting
and threaded elevatingshaft.
Recommended Lubricants:Dry Siliconeor Tenon
Lubricant
THREADED
HOLE
BEVEL
GEAR
ELEVATING S HAFT
TILT/ELEVATING MECHANISM
See _gure 70.
• Add dry [ube between me handle shaft and the boreof
the P.,bmping boil
• Add dry lube between the face of the clampingbolt
and theface of the handle sh_ft.
• Add dry lube on the inner surfaces of the bevel Ioclong
lever which corr_scts the cam.
CLAMPING
BOLT CAM
SURFACE
HANDLE
SHAFT
CAM
HANDWHEEL
BEVEL
LOCKING
LEVER
COMPRESSION
SPRING
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
Fig. 70
45