To Adjust Quick Stop - Craftsman 21829 - Professional 10 in. Portable Table Saw Operator's Manual

• Tighten
hex nut securely.
• Adjust rightrear screw from underneath miter table to
remove excessiveplay.
• Tighten hex nut securely.
• Recheck your setups carefully.Alse make sure a[[
screws, hex nu_s,etc., h_ve been tightened securely.
• If sliding miter table assembly is still not square with
the blade, repeat the above proceduresas needed.
• Make sure that sfidss remainsquareto miter base
edo,e to preve_ =oookir=_ =which will resultin excessive
play in miter table.
TO ADJUST QUICK STOP
See Figure 38.
The quick stop is preset at the factory to stop the miter
fence at sxactiy zero degrees. However,when sliding
miter table adjustmentsare made, these adiustmentsmay
cause the quick stop to need adiusting.Check qu(ck stop
with miter scale set at zero degrees. If adjustmentsare
needed, proceed with the followingsteps:
• Loosenthe eccentric screw holding the quick stop.
• Piecethe quick stop againstthe miter fence with miter
scale set at zero degrees.
• Adjusteccentricscrew untilit holds quick stop securely
a_]aJnstmiter fence.
• Rstk..lhtenhe);nut, secur{ngeccentric screw and q,qck
stop.
• Check yourwork. If the quickstop is not at zero
degrees, repeat above steps.
t
Q
Fig. 35
QUICK
STOP
Fig. 36
29